1 Reply Latest reply on Feb 15, 2010 1:32 AM by Deepak Gupta

    Defining load areas on surfaces

    Dan Balean

      Ok...

      I need to define an area on a surface where a load is applied (for my static structural analysis)

      E.g., on one face of a cube I need a 5x5mm area where a load is applied.

      What I do: sketch a 5x5 square and extrude/cut it 0.0001mm... to mark the area on the model.

      I don't think it's right but how can I do it properly?

      Thank you.