AnsweredAssumed Answered

Is it possible to have the fixed face be on the center of a part? (Sketched Bend)

Question asked by Chris Manger on Feb 8, 2010
Latest reply on Feb 8, 2010 by Chris Manger

I am modeling an old 2d part which I only have the flat pattern.  The part has a bend in the middle with a radius of 9".  When I use sketched bend and select the face, it bends the part on whatever side of the center of the bend.  Is it possible to bend the part so the resulting bend is symetric on that face?


See screenshot below.