After installing SW2010 (SP2.1) the goal parameter list in flow simulation disappear in both 2009 (SP5.0) and 2010. Have anyone had the same problem or an idea of how to solve this?
I just had the same problem.
Please try to update your flow simulation SP to the same level as SW.
my SW was in 2010SP2.1 whereas flow sim was in 2010SP1.
I upgraded Flow to SP2.1 and it solved my problem.
I just installed SW2010, SP 2.1, and am running a test case using flow simulation. I was able to add five goals to the project successfully.
The solver is running right now and I opened a goal plot to watch the progress. Interestingly, the progress bars are stuck at 0%, the criteria are all zero, with a comment message saying 'no convergence information'.
In previous versions it would insert the criteria automatically, is this something new where we need to add the criteria manually?
The solver is up to 0.58 travels at iteration 150, the criteria is still at zero.
I'm using heat transfer in fluid, conduction in solids, and humidity, but no radiation or gravity.
Still seems a bit odd, I'll be sure to post results after the solver finishes.
You are good! It's up to 1.73 travels, the criteria are in place and the progress bars are counting up.
An old SP might just be the source of the error. I got mine working again by removing both 2009 and 2010 completley, and then reinstalling only the 2010. Flow must have been SP1 before the reinstallation. Tanks.
Retrieving data ...