2 Replies Latest reply on Jan 30, 2010 12:42 AM by 1-4EQZK9

Surface curvature relation problems.

Derek Bishop Jan 29, 2010 10:44 PM

Computer has just crashed for the fifth time today. There seems to be a problem adding a surface curvature relation to a spline. Have two surfaces that I join with a spline. Select a surface, edge and spline to create the curvatre relationship. Did this on both ends of spline. Computer crashed repeatedly.

For one spline on some occasions I also added a tangent relation to make it tangent to a line on the surface.

Model attached. See the last sketch in the feature tree.

P1001250810 Speargun handle.SLDPRT.zip 1.8 MB

Re: Surface curvature relation problems.

1-4EQZK9 Jan 30, 2010 12:42 AM (in response to Derek Bishop)

Derek,

this does not crash on me - but again, I'm on SP3.0 EV so that isn't fair to evaluate your situation. I assume what you are saying is that as soon as you apply an equal curvature to both sides, that it crashes?

mark
Like Show 0 Likes(0)

Actions
- Re: Surface curvature relation problems.
  
  Derek Bishop Jan 30, 2010 1:48 AM (in response to 1-4EQZK9)
  
  Yes, that is correct Mark. An equal curvature in applied to both ends of the spline and this resulted in the computer crashing. I cannot see anything in the knowledge base on this. Will report this through my VAR. Thanks for checking. i'm using 2010 SP 2
  
  Any suggestions/tips on the best approach to surfacing this model are also welcome.
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post