0 Replies Latest reply on Jan 21, 2010 4:55 AM by David Mclellan

    Displacement image does not show on report?..

    David Mclellan

      I have carried out a wide variety of relatively simple simulations of which i then progress to publish a report on. Now however when i publish a report, it only shows the stress and strain images, NOT the displacement?

      I have tried creating all plots as JPegs, again only the stress and strain show up? I have also tried creating an additional displacement plot, once again it DOES NOT show up either as a JPeg or in any reports.

      I have reported this problem, and I have run the RX on it, but have yet to hear a reply.

      Anyone got any ideas?..

       

      Note:

       

      For the attached file, the only load experienced is gravitational effects, and the displcement which i am after is in the Y-Axis.

       

      any indication of why it has done this would be greatly appreciated!