Dear Onias Martin,
Lateral thinking is the solution. Lofted Bend with two sketches from top to bottom instead of
along the length of the part.
The solution is attached . The cut to achieve your contour is put in after unfolding.
The principle solution is attached tweak and use.
Since I didn't hear from you. I decided to improve the solution to an exact match instead of a generic one
that was earlier posted.
The problem presented by you is a set of features in the folder Problem Sheet Part . This was the one
that could not be converted to a sheetmetal part because of the modelling approach.
The solution is located in the feature folder Solution Sheet Part . The basic modelling is one feature
with two loft sketches from top to bottom of the part .
I've even coloured your part in red and the solution in blue . You can see like you said it can be done .
Retrieving data ...