Can someone tell me what is wrong with this model, and my cut list? I know I could not get the shelf in the middle to be sheet metal. I also need to add doors and skin with 18 gauge sheet metal. I am going to continue with it but not sure which direction I will go in, I know I can go into the cut list and edit the properties so that is what I am going to do. What is it I did wrong? any ways of adding sheet metal around the part?
life is like grapes, all purple and green f***ed up looking, until you crush them, make wine, and get smashed. then we can see the world for what it is, spinning out of control thru the universe just u will be to smashed off the wine. lol
If its the blanks in the table, the custom properties are not filled in for these parts in the cut list., not sure what you mean by whats wrong with the model.
(Just a suggestion, You should use fully defined sketches, a - sign in front of a sketch means it is underdefined.)