AnsweredAssumed Answered

Mating coordinates for 1st part in an assembly

Question asked by Dan Balean on Dec 15, 2009
Latest reply on Dec 15, 2009 by Dan Balean

1st part in an assembly has a fixed position,and I can't match planes or origin with the system's.   Is there a way around that?   I'm putting together a spindle and I want the shaft to turn; however, as it is the 1st part imported into the assembly it's fixed, and the planes are not even coincident, section through the assy goes at a weird angle.   If I start witn another part, the same thing happens.

Any ways around this? 

Thanks.

Outcomes