AnsweredAssumed Answered

Centre of Gravity - How to?????

Question asked by David Mclellan on Dec 8, 2009
Latest reply on Dec 8, 2009 by Jim Sculley

I am trying to locate the COG of the attached assembly, I would then like to create a sketch which indicates the rigging outlines, which meet at the COG to ensure an equal lift.

 

As it stands the centre lifting point is not indicative of the COG.

 

I have tried runnin 2 different Macros: "Centre of Gravity" & " Centre of Mass" Neither seemed to do anything?

 

Any help on how to run these macros or how to locate the COG would be greatly appreciated

 

Dave (SW 10.0)

Outcomes