AnsweredAssumed Answered

Attaching remote loads/mass to shell in 2010

Question asked by 1-1KYWMD on Nov 30, 2009

We have a shell model that was done in 2008 Designstar which has a bunch of point masses and are using gravity to induce loads.  When brought into 2010 SW the point masses are ignored from all calculations.  I've tried redefining them completely, defining them as remote loads, tried in 64 and 32 bit and it just ignores them.  When brought into 2009 it worked fine without any fixing.


Any idea what would need to be done to have them recognized in 2010 SW?  I tried a simple model and it worked fine...but not on the one that counts!