AnsweredAssumed Answered

Part Configuration Problem

Question asked by Ed Scheid on Nov 20, 2009
Latest reply on Nov 23, 2009 by Mark Kaiser

When I make an assembly with multiple configurations, I cannot open a part and change its configuration to show something other than what the assemblies current configuration is. The same goes for drawings. If I make a drawing of a part from an assembly, I can only show the  part configuration from the assemblies current configuration.

 

I have attached an example. The butterfly valve has 8", 10" and 12" configurations. If I set the assembly to show the 10" butterfly valve and open the shaft, I can only see the 10" configuration for the shaft. If I select the 8" or 12" configurations for the shaft, it will only show the 10". Is there something wrong with my configurations?

Attachments

Outcomes