Todd Bohlen

End caps & member trimming

Discussion created by Todd Bohlen on Apr 7, 2008
Latest reply on Apr 7, 2008 by Todd Bohlen
So I sketched a little frame with 4 vertical tubes at the corners and 4 horizontals at the bottom to tie them together. The verticals extend to the floor and the horizontals butt to the verticals. I need to cap both ends of the verticals, but SW keeps aligning the bottom of the horizontals with the bottom of the vertical tubes, rather than with the bottom of the end cap. I want the bottom to be flush all around and CANNOT figure out out to make this happen.

Any ideas?

Thanks!

Outcomes