AnsweredAssumed Answered

2009 assemblies exploded in 2010?

Question asked by Andy Ahn on Nov 4, 2009
Latest reply on Nov 10, 2009 by Andy Ahn

Well this would be my first thread in this commuity although I've been visiting here often & you guys are great.

I've been using solidworks since 1998 version so I would say I know quite a bit about this software.

 

It just happen this moring I opened an assembly file(that I was working in 2009 version) in 2010 for the first time and all parts and sub-assemblies in there were a total mess. Usually mates... I think... It's quite complicated assembly though, with many configurations and sub-assemblies in there which also have many configurations and quite big too. There wasn't a single configuration that's working, there were some that are close though.

 

Maybe I'm missing something simple, a setting or option or maybe this is one of gliches that 2010 have, I can't say. I was justing wondering if any of you experienced somthing like this or hopely a solution too.

 

As I would investigate this, if something comes up I'll post here. Thanks.

 

 

Outcomes