AnsweredAssumed Answered

louver in Sheetmetal exam

Question asked by 1-A1W2PM on Oct 27, 2009
Latest reply on Oct 27, 2009 by 1-A1W2PM

Hello! Could someone help me please! Today I've tried to pass the Sheetmetal Exam.

The first 10 questions were not really hard but the next 4 presented this problem: the louver.

The question shows where to place it but nothing else. It doesn't say if one should cut a hole in the

material attaches to, it doesn't say that one should apply the same material for the louver as for the

rest of the part... there is a lot missing from the instructions... Has anyone passed this exam?

Has anyone knowledge in this matter? I would appreciate very much some help!

 

Thank you!

George

Outcomes