Sometimes, when I close a scene or want to save my work, PV360 pops up an error message and says it won't save. Sometimes, it saves my work. This is quite strange. Any ideas?
Faith,
Is the same part or assembly file (that you have loaded into PV360) still open in SW? If so, you must close it first before you save your PV session.
Regards
Mark
Yes, it was open. I thought it was so because I noticed this "not-saving" trend only when files were open in the backgrd in SW.
Thanks Mark for the reply.
Faith,
Is the same part or assembly file (that you have loaded into PV360) still open in SW? If so, you must close it first before you save your PV session.
Regards
Mark