Have an edrawing and I can't see any of the measures, I can click the measurements button and click an item but nothing gives me a number, Would someone like to get the numbers for me.
Help..
Mike
Have an edrawing and I can't see any of the measures, I can click the measurements button and click an item but nothing gives me a number, Would someone like to get the numbers for me.
Help..
Mike
If the measure button is greyed out , No
You could ask them to send it again with the measure enabled
Michael
It is not grayed out, ever measurement says it is a planar or something but I get no measurement,
Even if it was is there a way to get the measurements?
Thanks..
Have you selected 2 objects to measure eg 2 different edges or 2 faces.
When I select just one face I am getting "The selected face is planer" but if I select a second face I get the dimension.
Michael
Let me know...
Thanks..
When I run this file the measure has not been activated.
You can select the measure on the right hand side of the screen but when you do the I get the measure icon greyed out.
Michael
Edit
And I answered the wrong one
Are you trying to measure a curved surface?
If so try to use an edge or a point to get your size.
Ok I can grab every peice in the drawing with the tape tool.
How can i get measurements without a new file?
hello
this works fine in my edrawings. measurements are in inches.the shaft is 0.21 in diameter. what dims do you need?
Snap with the shaft Ø
I hate to say i need them all for every peice but If I can get it to work it would be easier, any ideas.
Thanks....
Mike
Mike,
If you select the end of the shaft what size are you getting ?
Don't think you can save the sizes.
try this.
What do I need to do to see measurements?
use your measure tool.
try this file too.
HI Mike,
Which revision of Edrawing is put into use? I remember when I used "basic edition", i could not use measurement tool.
I think the "professsional edition" will solve your problem...Hope it works!
I can get the green items selected but don't get the measurement.. Is there a step by step on the procedure..
Sorry to be a pest.
Can the measurements be saved in the file?
Mike
Am I suppose to be in a different mode?
I think the person who sent the file has to enable measuring
Michael