AnsweredAssumed Answered

BOM, Custom parts and the Toolbox

Question asked by Andy Schuler on Oct 8, 2009
Latest reply on Oct 8, 2009 by Andy Schuler

I'm researching the implimentation of Toolbox here at work, and I have a few questions about Toolbox components. As such, I am new to Toolbox and might just not understand it enough, so any help would be appreciated:

 

  1. Is there any way to store mass/weight information in a toolbox component that will show up on a bill of materials? Mass properties and moments of inertia are critical to us, so we need a way of retaining that information through to a BOM and weight statement.
  2. If I want to add a new component that, say a locating pin (not a simple pin like the ones already in there, but one that has features that will vary from configuration to configuration) , is there a way to set it up so that you can select the pin diameter just like you can select the thread size, and have the locating pin auto-generate? Or is it better to put each locating pin model into the design binder?

 

Thanks for your help.

Outcomes