Our student assignment was to draw a cylindrical bearing holder with concentric steps in it. The orignal 3D paper sketch showed an isometric view with a 90° section cut out to illustrate the dimensions.
I asked the instructor how to show a section view like this in SolidWorks. I was told it was not possible, and could find no commands to do it. I find this hard to believe. Any way to do it?
Check these two posts for Isometric section view
http://gupta9665.wordpress.com/2009/02/05/how-to-create-iso-section-view-1/
http://gupta9665.wordpress.com/2009/02/05/how-to-create-iso-section-view-2/