AnsweredAssumed Answered

No bend line notes in drawing of flattened sheet metal?

Question asked by Rachayl Duker on Oct 1, 2009
Latest reply on Oct 22, 2009 by Rachayl Duker

Hi,

I created my own flattened configuration in a sheet metal part since none was created automatically. (why not, by the way?)

When I make a drawing of this flattened config there are no bend line notes.

(Yes, I do have "display sheet metal bend notes" selected in Document Options>Sheet metal.)

Why not? Can I get them to show up somehow?

Am using SW2009 SP0 tho I had this problem sometimes in SW2008 too.

Outcomes