How do I open an old version of a part without deleting the newer revisions of a part? I am hoping to use pdmworks to track the evolution of components as I develop them in an FEA package but I can't see an obvious way of getting at the "old" geometry.
Many thanks,
Mike
Hello Mike-
All revisions of all files are stored in the vault. In the screen shot below, you'll see I have 26 revisions of this assembly, anyone of them is available.
Devon Sowell
I didn't want to start a new discussion so I did a search on how to open an old version of a part. This does not tell me how to get to this folder, all its showing is the old version is saved in a folder but how do I find the old version and open it in SW?
Just pick the revision that you want to open from the list that Devon showed. You may also want to check the As build radio button so that it will get the revision of the components when the assembly was in that revision.
Hello Mike-
All revisions of all files are stored in the vault. In the screen shot below, you'll see I have 26 revisions of this assembly, anyone of them is available.
Devon Sowell
http://www.pdmsolution.com