Back in SW 2007ish, you could "Create all configurations" of a certain fastener. Is that still posible in 09?
Yes it's possible but it's well hidden. The Import/Export/Create Configurations popup window is located just above the RH vertical scoll bar when your in 2-Customize Hardware and explore to the part level. It's at the far RH end at the same level as the Size Finish Thread Display ... Comment columns. The button looks like 3 horizontal lines with a small arrow underneath. When you scoll over it Import/Export is shown and the Create Configurations option is displayed when you click on it.
Hope you can find it from this roundabout description...I found it by accident. Once you know where it is you'll wonder why it wasn't obvious.
Screen shot attached...I hope.
Import/Export, Create Configurations shown on RHS
Retrieving data ...