Aaron Larson

Isn't Toolbox supposed to be industry standard?

Discussion created by Aaron Larson on Sep 22, 2009
Latest reply on Sep 22, 2009 by Aaron Larson
I believe I was told or have read at some point that all toolbox parts are "industry standard" items.  If this is the case why can't I find 6.00x6.00x.375 square end aluminum angle?  I specified this in a design believing this was an "industry standard" item.  I found from my vendor that this item could not be found.  Are there any other items in the toolbox that could lead to this problem?

Outcomes