1 Reply Latest reply on Aug 30, 2009 10:38 PM by Deepak Gupta

    Define Title Block

    Tim Cochrane

      I just did this to one of my drawing templates as outlined on page 95 of "whats new".

       

      I was assuming it would backfeed the info I put into the light blue blocks back into my part or assembly. I was incorrect.

       

      When I filled in the light blue blocks it puts it on one long line across the rest of the info in my title block. Useless!!

       

      Now I have gone back into the part to put the data in at the part level. It will not feed into my title block.

       

      Is there a way to correct this?


      Tim