-
Re: Double clicking to end line in sketch results in sketch disappearing.
Question: How long is the line that your drawing?
I have seen this happen on verry long lines in sw 08
-
Re: Double clicking to end line in sketch results in sketch disappearing.
The line could be a few inches or a few hundred, it happens every time.
here's a before and after look at what I'm seeing..
-
Re: Double clicking to end line in sketch results in sketch disappearing.
Just click OK and come out the sketch mode. Save you part and upload here to look at. Also knock your VAR/SW Customer support door to check with them. may be a SPR required.-
Re: Double clicking to end line in sketch results in sketch disappearing.
its not A part.. its all sketches. I was just wondering if anyone else saw this before opening an SPR..
and I shouldn't have to click 'ok' or anything else. A double click is supposed to end the chain of lines, not make the sketch disappear.. lol
-
Re: Double clicking to end line in sketch results in sketch disappearing.
hi Tom
yep this happens to me randomly. the sketched line disappears. doh. if i close the session of sw and open up again it works for a bit then goes again. i have a keyboard shortcut key for 'show hiddenline view'. click that and the line comes back! nothing to do with sketching i know but it seems to get the video back. very frustrating. vista x64 like you. thats what it is. their x64 bit coding is rubbish!
-
Re: Double clicking to end line in sketch results in sketch disappearing.
Ahh ok, so once you change the view from one to another, the lines will show back up.. Least that will keep me from exiting out of a sketch every time I forget not to double click
Thanks Mart
-
-
-
-
-
-
Re: Double clicking to end line in sketch results in sketch disappearing.
After you are in dimension mode you need to click OK or click on Dimension tool to get back into the sketch/line mode. Can you add a video or series of picture to show. -
Re: Double clicking to end line in sketch results in sketch disappearing.
The double click ends the line function not the dimension.-
Re: Double clicking to end line in sketch results in sketch disappearing.
Yea I know.. and everytime I do it on my system, the lines disappear.. look at the above photos in one of my posts.
-
Re: Double clicking to end line in sketch results in sketch disappearing.
What happens if you hit escape instead of double-clicking?-
Re: Double clicking to end line in sketch results in sketch disappearing.
the line tool turns off. Which is a bit better.
Double clicking while creating a line will end the chain creation, but not escape the line tool. which I use extensively. I did send it to my VAR, but haven't heard anything yet.
-
-
-
