David Clark

Sketch Points Not Closing

Discussion created by David Clark on Jul 11, 2009
Latest reply on Jul 13, 2009 by Deepak Gupta
When I am sketching a rectangle (or any closed linear geometry) SolidWorks draws it as four individual lines rather than a single geometry and the corners are not necessarily closed, that is I have to sometimes select the corner points and merge them to close the rectangle.

Also if I drew a line starting at one of those corners, the point would turn red making me think I am coincident with the point & it may appear so, but on zooming it I see they are not.

Any help is appreciated, I am using the 2007-08 Student Edition.

Thanks in advance.

Outcomes