Some of the end connectors on my electrical routes "fly away"
and become disconnected from the wires in the flattened state. Or
it could be that the component is staying fixed in space while the
rest of the route flattens.
Is there some mate reference or something like that to look for in the 3d sketch? They look fine in the default configuration. I can actually drag the connector component and the wire follows, so I know it is connected.
Is there some mate reference or something like that to look for in the 3d sketch? They look fine in the default configuration. I can actually drag the connector component and the wire follows, so I know it is connected.
My guess would be that the ones that are misbehaving are maybe multi-cpoint connectors. These don't behave well with flattening.
I'd like to say that this is definitely fixed in 2010, at this point in time it's 50/50 whether or not this will make it. We will try to get this support in for 2010 if we can get the functionalityto be stable enough.
Regards
Andy