I am using some bolts and nuts and washers in my assemblies
from the toolbox, and I'm loving it, however this makes my
assemblies under-defined.
The toolbox parts make a concentric and coincident mate and I'm fine with that, an extra mate to fully-define it would just bloat up the amount of mates. But I still don't like the fact it makes my assemblies turn up not fully-defined.
Is there an option somewhere to discard toolbox fasteners from affecting the global assembly "fully defined" status at the bottom?
The toolbox parts make a concentric and coincident mate and I'm fine with that, an extra mate to fully-define it would just bloat up the amount of mates. But I still don't like the fact it makes my assemblies turn up not fully-defined.
Is there an option somewhere to discard toolbox fasteners from affecting the global assembly "fully defined" status at the bottom?