Hello -
I was wondering if there's a way to isolate a pair of components with a mate error so that it can be seen and repaired easier. I've got component descriptions turned on at the end of my component tree in the mates area and this helps a lot. But, I thought it would be neat to pick one of these pairs and automatically isolate them from the rest of the assembly. This would work especially well if the parts are deep inside!
-Lou
I was wondering if there's a way to isolate a pair of components with a mate error so that it can be seen and repaired easier. I've got component descriptions turned on at the end of my component tree in the mates area and this helps a lot. But, I thought it would be neat to pick one of these pairs and automatically isolate them from the rest of the assembly. This would work especially well if the parts are deep inside!
-Lou
