Guy Jones

Component Orientation Electrical

Discussion created by Guy Jones on Jun 23, 2009
Latest reply on Jul 17, 2009 by Kirk Jess
I'm new to using routing. I have created cable/wire library and am building a component library.
Here's my problem. When I drag and drop connectors into an assembly to create a wire route subassembly, I can't orient the connector in the direction I need.
An error message states that the position is defined. It appears that the connector is fixed in the orientation it was created.
The only mate references I've put on them are "Concentric" and "Mate Face".
I think I should still be able to rotate the component. Shouldn't I?

I'm sure I'm missing one piece of the puzzle here.

Outcomes