AnsweredAssumed Answered

OPEN HEM 4 SIDES WITH 45 DEG

Question asked by CHRIS HOLSKE on Jun 23, 2009
Latest reply on Jun 23, 2009 by CHRIS HOLSKE

Like • Show 0 Likes0
Comment • 5

I am trying to create an open hem on all 4 sides of a panel and I would like them to meet in the corners at 45 deg. Can I modify the hems to be 45 deg in the corners?

Deepak Gupta Jun 23, 2009 1:08 PM

Correct Answer

Chris,

Pick all the edges in one feature or one go only.

Check this picture: http://img269.imageshack.us/img269/149/hem45.jpg

See the reply in context

No one else had this question

Outcomes

5 Replies

Steve Calvert Jun 23, 2009 11:33 AM
Mark Correct
Correct Answer
Chris, it almost sounds like you're talking about a Miter Flange more than a Hem. Can you post a picture of what you're after?

You can't modify the sketch for a Hem feature, BTW.

Steve
Like • Show 0 Likes0
Actions
- CHRIS HOLSKE @ Steve Calvert on Jun 23, 2009 11:47 AM
  Mark Correct
  Correct Answer
  Steve, I think you are right, I tried miter flange but wasn't sure on how to do it.
  I have attached a small file of what I am trying ti do.
  Thanks, Chris
  Attachments
  - flange test.zip74.9 KB
  Like • Show 0 Likes0
  Actions
  - Deepak Gupta @ CHRIS HOLSKE on Jun 23, 2009 1:08 PM
    Unmark Correct
    Correct Answer
    Chris,
    
    Pick all the edges in one feature or one go only.
    
    Check this picture: http://img269.imageshack.us/img269/149/hem45.jpg
    Like • Show 0 Likes0
    Actions
    - CHRIS HOLSKE @ Deepak Gupta on Jun 23, 2009 1:12 PM
      Mark Correct
      Correct Answer
      Very nice, and simple too. I should have been able to find that but I have been strugling with it for an hour! Thanks a bunch!
      Like • Show 0 Likes0
      Actions
  - Drew H @ CHRIS HOLSKE on Jun 23, 2009 1:12 PM
    Mark Correct
    Correct Answer
    Here ya be
    Attachments
    flange-test2.zip91.2 KB
    Like • Show 0 Likes0
    Actions

OPEN HEM 4 SIDES WITH 45 DEG

Outcomes

Attachments

Attachments

Related Content

Recommended Content