Roche Du Toit

Controling a Derived Part's configuration?

Discussion created by Roche Du Toit on Jun 14, 2009
Latest reply on Jun 15, 2009 by Dwight Livingston
I have the following:
1. Assy with 3 parts
2. The seed part (derived Part) as the first part in the assy.
3. 2 parts containing the derived(seed) part
Now if i make any geometry changes to the seed part everything else follows. The seed part has design table driven configurations. now when i change the seed config i expect the derived parts also to change but they dont and there is no way to take control manually!

Outcomes