AnsweredAssumed Answered

what's wrong about the equation?

Question asked by wenyang wang on Jun 11, 2009
Latest reply on Jun 11, 2009 by wenyang wang

Like • Show 0 Likes0
Comment • 4

I try to use equation to calculate the upper solid width in the context of assembly, but it don't work. for example, if i change the assembly configuration, the width don't change. pls. check the attached file created under solidworks 2009 SP0

ATTACHMENT

No one else has this question

Outcomes

4 Replies

Mark Kaiser Jun 11, 2009 1:55 PM
Mark Correct
Correct Answer
Your file didn't attach, see below thread if you need help attaching files.

http://forum.solidworks.com/fo...catid=8&threadid=13518
Like • Show 0 Likes0
Actions
- wenyang wang @ Mark Kaiser on Jun 11, 2009 3:27 PM
  Mark Correct
  Correct Answer
  thank you. i have attached the file "attachment". could you help me check it.
  Like • Show 0 Likes0
  Actions
Josh Brady Jun 11, 2009 6:57 PM
Mark Correct
Correct Answer
Setting up your equation in this way references the active configuration of the part you are referencing, not the configuration in the assembly. You need to figure out a different way to define this in context. For example, instead of using some dimension -20, just add a 20mm dimension from a different edge.
Like • Show 0 Likes0
Actions
- wenyang wang @ Josh Brady on Jun 11, 2009 8:28 PM
  Mark Correct
  Correct Answer
  still confused. could you just take this part as example to explain it to me. or send the finished part to my email (wenyang@ecatia.com).
  Like • Show 0 Likes0
  Actions

what's wrong about the equation?

Outcomes

Related Content

Recommended Content