AnsweredAssumed Answered

cut a 'lead-in' into piece of a part on a varying angle

Question asked by Lauritz Berg on Feb 11, 2021

In the last months, we started to optimize our parts to be cut faster by our plasma by doing the following:
Parts like this

Get a 'lead-in' like this

 

is there a better way to do this (fewer/smarter features) than

  1. cut extrude
  2. fillet (full round)
  3. fillet (full round)


It just breaks so often, when changing a part.

Did I miss something very obvious?

Outcomes