AnsweredAssumed Answered

Sheet metal flange help

Question asked by David Lane on Feb 9, 2021
Latest reply on Feb 10, 2021 by David Lane

I am trying to create a flange at 0 degrees like below, except as a single part.

 

 

I have tried cutting out the material (remove top and sides) and unfolding (the unfold won't work).

 

I have tried cutting out the material (all) and adding a base flange. It is as shown in the photo and makes it's a multibody part.

 

I have tried cutting out the material (all) and doing a swept flange. The result is identical to the photo and is also a multibody part.

An edge flange cannot be 0 degrees.

So how should I go about this?

P.S. can't attach the part for confidentiality reasons

Outcomes