Anybody know of a way to show the 2nd extension line on this diameter dimension?
Other than sketching one in.
It's not critical, just think it would look nicer than a dimension arrow pointing to nothing
How did you make that dimension? When I tried it I got a radius dimension. When I set it to show as diameter I got the second extension line, but it was on the same side as the first one (going back to the radius reference).
Thanks for the reply Glenn,
Inserted it with smart dimension, comes in as radius. Changed to diameter on leader tab.
I'm also still running SW 2017 . Maybe that's why ours behaves a bit differently.
Changing to a diametral dimension is just a display state (if you will), but underneath it's still a radial dimension entity, so I don't believe you can add a second extension line as it technically doesn't exist.
One suggestion is to position the diametral dimension close to the opposite arc edge:
Retrieving data ...