Doug Perzyk

Broken Dimension

Discussion created by Doug Perzyk on Jan 22, 2021

Just had an issue where an OD dimension in a detail view somehow was broken. That is it was off by almost .200. It did not display as dangling either. To elaborate a bit more, the main view was on one page and the detail view on another. I dimensioned the diameter before I moved it to another page since I needed the main view to dimension it (being a detailed view and the full diameter was not visible in the detail view). I wish I could share the drawing and model but it is military. Has anyone else experienced this? I sure have not. I must have grabbed a point or something when I created the dimension. Almost scrapped out the job... Ugh...

Outcomes