This content has been marked as final. Show 3 replies
Sorry for the obvious question, but did you try holding down the shift key while dragging the dims from the standard view to the detail view?
Assuming you are talking about model items. I have come across the same problem. How the dims come into the drawing relate to how they are put into the model i.e. if one has dimensions on the right plane in the model the section view in the drawing would have to relate to the right plane. This should drive the dimensions into the drawing. If your section is through the front plane in the drawing and dimensions on the right plane in the model, this could cause your issue.
Also on detailing detail views of sections one may have to expand (enlarge) the detail view to incorporate the dimensions you are trying to pull i.e. foreshortened dimensions, then decrease your detail view to what you would like to see.
Hope this information serves you well,
Enlarging the detail circle temporarily so the dimension showed up in the detail view worked. I moved the dimension into place and then reduced the detail circle back down.