AnsweredAssumed Answered

Issues w/ Cut Extrude @ end of a cylinder?

Question asked by Clark Jacobs on Jan 16, 2021
Latest reply on Jan 18, 2021 by Clark Jacobs

Hi,

 

So in the attached part, there are two legs ("Rods") that come off of the top spiral. See the bottom faces of the rods? I want those to be parallel to the Top Plane, and I tried to accomplish this through the means of the "Cut Leg Ends" feature (an Extruded Cut).

 

However, when I did this, the orientation of the bottom faces remained unchanged.

 

Anyone have any ideas as to what I could be doing wrong, or should do differently?

 

Thanks in advance !

Attachments

Outcomes