AnsweredAssumed Answered

LOFTED CUT MAKING STRAIGHT LINES

Question asked by Etienne Bouffard on Jan 15, 2021
Latest reply on Jan 15, 2021 by Matt Lombard

In sw 2015 when I was making a lofted cut the lines created between the 2 profiles where straight.  Now in 2021 the are curved splines.  When I try to use this profile for wedm machining the curves make the programmation impossible.  Do you know how to force the jonctions between the 2 profile to be straight?  In the image below u can see in the right bottom the arc lenght propriety.  Proving the line is not straight but a curve.

Outcomes