I have created a K factor Gauge table I was wondering first if there is a way to see how to check the k factor in the software right now when I look at the bend it just reads Gauge table so I have to trust my chat is working. I was hoping there is another way to check it.
My second and main question is when I use the table and create a part with one radius and k factor when I try and change the radius to another one on the drop down it errors for the k factor. Is this happening because my chart is wrong or is this an error in the software. It works fine is I do one or the other the first time but when I try to switch it after making the part it errors