AnsweredAssumed Answered

Newbie here - help on modeling this part?

Question asked by Bill Devine on Dec 28, 2020
Latest reply on Dec 28, 2020 by Maha Nadarasa

So, I've got a part I need to finish modelling. I've got part of it done as you can see in the attached file. I need to make it look like the attached picture. 

 

The angle starts approximately 1" back from the front, at about 27 degrees. The numbers aren't critical as long as it looks like the picture somewhat. There is a flat back you can't really see in the picture. I'm just not sure where to begin to do this. Thanks!

Outcomes