AnsweredAssumed Answered

DWG Linetype representation

Question asked by Andrew Dunsdon on Jun 4, 2009
Latest reply on Jun 4, 2009 by Andrew Dunsdon
Good morning everyone. I am a newcomer to this forum and I am in need of some assistance. I must state from the outset that I am not a Solid Works user but please bear with me.
Our IT dept has installed eDrawings viewer to enable our thin-client users to print .dwg drawings via citrix. This morning we discovered that the viewer had rendered dotted lines and centre lines as solid lines. Needless to say, it was a sub-contract machinist that pointed this out! My question is this: Is it possible to change the settings within eDrawings viewer so that the linetypes are shown correctly? I have looked for a set-up / options screen but without sucess.
I would be most grateful for any assistance you can offer.

Thanks.

Drew

Outcomes