AnsweredAssumed Answered

How to "bend" some modeled "tabs/ears" up at an angle from center?

Question asked by John Gaertner on Dec 6, 2020
Latest reply on Dec 7, 2020 by Krzysztof Szpakowski

Hello Forum,


I am trying to model a part that will eventually be 3D printed on an PLA printer. Using SW 2014.

Attached is the file. I need to bend the 3 pedals or ears up from the center slightly to make the 

shape correctly. This was just a 2D sketch so I could get some help. Size and shapes are correct.




flat 2D image of part need to bend pedals upward slightly.