Since you have the part, why don't you just measure it?
The time you spend photograph already enough for you to measure and draw.
Hmmm Solidworks is 3D modeling, not photo edit .....
Can I cut a steak with a fork?
No sure can't.
Frederick Law schrieb: Can I cut a steak with a fork?
Frederick Law schrieb:
Of course! You should! Buy a good tenderloin and forget about the knife...
I'm struggling with getting the dimensions right for orthogonal planes now. The dimensions are off terribly. Does recap360 provide a model or is there another solution to take better photos.
leave the active sktech, and edit Sketch14. Then double-click the Sketch Picture2 and zoom out. Now you can see the Scale Tool and use it to adjust the size of this picture.
Retrieving data ...