AnsweredAssumed Answered

How to run multiple NL-static studies (multiple varying geometrical parameters) similar to a design study.

Question asked by Kevin Le Gall on Nov 30, 2020

Hello everyone,


I'm trying to converge to an appropriate design for a lip-seal. I'd like to run multiple parallel studies with varying fillet radii, and angles. But I can't seem to figure out how this works.


As of right now I'm running Non-linear-static studies with axi-symetric simplification and the simulation is basicaly moving the shaft through the lip-seal and recovering the traction&compression stress values.


So would there be a way to fill a list of values for each important geometrical parameter and run every simulation at once ? 


Thanks in advance for the help,


Have a nice day.