I have a assy. that I did years ago that I need to bring into
SW2009 SP3, it imports ok but... it now is a assy. and has no
mates.
What I can't figure out is how can I use Feature Works in a assy. without having to open each part (about 200) rename and then rebuild the assy. and try remember where they mate from 10 years ago from the ground up.
Is it even possible?
Dan
What I can't figure out is how can I use Feature Works in a assy. without having to open each part (about 200) rename and then rebuild the assy. and try remember where they mate from 10 years ago from the ground up.
Is it even possible?
Dan