I would like to add some custom codes (M01) in my Operation Tree. Is that possible?
Using SW 2020 with Standard CAM.
I would like to add some custom codes (M01) in my Operation Tree. Is that possible?
Using SW 2020 with Standard CAM.
You can add a post operation by selecting the operation before where you would like the M01. Right Click and select "Insert Post operation" If your post supports it select "Program Stop" and select optional stop. Then press the insert button
You will see an program stop operation appear in your tree.
This will all depend on your post processor.
Cheers!
Thank you! I had my post processor set wrong for the learning environment!
I see Post Operation now.
You can add a post operation by selecting the operation before where you would like the M01. Right Click and select "Insert Post operation" If your post supports it select "Program Stop" and select optional stop. Then press the insert button
You will see an program stop operation appear in your tree.
This will all depend on your post processor.
Cheers!