AnsweredAssumed Answered

Creating 2 different raddi in a slot

Question asked by Samuel Hartley on Nov 6, 2020
Latest reply on Nov 7, 2020 by J. Mather

I am going to be cutting the slot with a 5/16 diameter endmill with 1/8 corner radius. When drawing the part. I want to include the corner radius in the drawing. I attempted doing so by a split where the corner begins (the black line seen on the bottom face of the slot, but the fillet feature still creates a fillet covering all the bottom edges of the slot. Any insight would be helpful.

 

Thank you

Outcomes