I changed the dimension between several holes. Below I'm showing one that changed from 5.14" to 7.84". The model does not update as expected, it still measures 5.14".
The sketch shows the change that was made:
I haven't taken extra steps in the past to have a model reflect an edit to the sketch. I noticed that if I went into "Edit Feature" and clicked the green check mark then the model correctly reflected the change.
The need to go back to "Edit Feature" is random; it doesn't always require this step. This didn't happen in previous versions of SolidWorks. Has anyone else experienced this? Is there something I'm doing wrong? Is this a bug in the software?