AnsweredAssumed Answered

Properly dimensioning a hub

Question asked by Collin Zeng on Oct 7, 2020
Latest reply on Oct 8, 2020 by Kenneth Barrentine

Can someone help me troubleshoot this part?

 

I've attached the SLDPRT file to the post. I'm very close to the right geometry. I'm just a little bit off in terms of mass and surface area. I believe the problem lies with the positioning of the holes in the hub. They aren't fully defined, and I can't figure out how to fully define them. I'm also unsure what the slanted lines in the below diagram of the part are supposed to represent (circled in red). 

 

Attachments

Outcomes